Routine Maintenance

Routine Maintenance Checklist:

Having a contractor in for annual preseason checkups helps keep air conditioning and heating systems at peak performances. Maintaining equipment prevents unnecessary problems and unwanted costs. Contractors are busy during peak seasons. Consider having them check cooling systems in the spring and heating systems in the fall, usually during daylight saving months.
Typical maintenance check lists include;

Thermostat settings ensure cooling and heating operations keep you comfortable when you’re home and cuts energy use when you’re not
Electrical connections should be tightened. Voltages and currents on motors should be measured. Poorly maintained electrical connections cause unsafe operation of your system while reducing the life of all components.
Lubricate moving parts. Friction causes additional resistance in motors and increases the amount of electricity used.
Inspect the condensate drain in central AC units, furnaces and heat pumps (for cooling modes). Plugged drains cause overflows and water damage, affecting indoor humidity levels.
Controls ensure safe and proper operation. Check that the system cycles (starts, operates, and shuts off), properly.
Cooling Specific:

Evaporator and condenser air coils. Dusty, dirty coils reduce a system's ability to cool your home. They cause the system to run longer, raising energy costs while stressing the life of the equipment.
Check and adjust the refrigerant level of your central air conditioner. Too much or too little refrigerant is another symptom of a less efficient, energy increasing and life reducing system.
Clean and adjust blower component. This provides proper airflow for greater comfort. Airflow problems cause system reduction up to 15 percent.

Check gas and oil connections. . Improper connections are a fire hazard and can contribute to health problems.
Gas pressure. Natural gas contains approximately 5% moisture. This can cause the diaphragm in pressure regulators to freeze in some winter climates. Rust preventing paint can help prevent leaks at joints.
Burner combustion and heat exchanger. Dirty burners or a cracked heat exchanger causes improper operation. Either will cause equipment malfunction.

Actions To Do Yourself :
- Inspect, clean and change air filters. Your central air conditioner, furnace, and/or heat pump filters should be maintained at least once a month. Your contractor can show you how to do this. Good filtration can keep energy costs lower and aide in the longevity of your equipment.